According to standards set by the federal government, a low-flow showerhead uses no more than 2.5 gallons of water per minute at a water pressure of 80 pounds per square inch. That’s less than half the rate of water used by some older traditional showerhead models. Low-flow showerheads come in two main types, aerating, which creates a mist, or laminar-flow that sends water out in a steady stream.
Justin D and Eric worked on four leaky spots in one afternoon replacing toilet parts, bathroom sink fixtures, shower fixtures and an ancient outdoor spigot that required going into the crawl space. All were done efficiently and with detailed explanations. Additionally, each work area was left completely cleaned up. I appreciate that they also alerted me to a duct work problem under the house which I may not have discovered for some time. My parents, also customers, and I are happy to give a big thumbs up to Atomic Plumbing. Thank you Justin D and Eric! Good team!
Average Americans work well into their 60s, so workers might as well have a job that’s enjoyable and a career that's fulfilling. A job with a low stress level, good work-life balance and solid prospects to improve, get promoted and earn a higher salary would make many employees happy. Here's how Plumbers job satisfaction is rated in terms of upward mobility, stress level and flexibility.
Are you looking for the best plumbers in Columbia Missouri, with 20 years of experience and the highest customer satisfaction rating in the city? If so, you've found them! A1 Columbia Plumbing, Heating & AC offers you quick service, affordable rates and high quality materials. No job is too big or too small. We are your complete plumbing service, available daily.
I was disappointed with the pressure of a tub and shower that were plumbed with 1/2 supply lines (2nd floor). Could be low pressure from the street, but I want to replace with 5/8. Plus, I'd like to have 2 back to back showers, one inside and one outside. So, I had intended to bring a 1 supply to both, then branch up to valves and shower head with 5/8. Finally, I thought pressure from the street was typically 55 to 70 psi and I am concerned if pvc can take that.Any thoughts?