CON'T FROM COMMENTS EARLIER.  However,  the  installation took less than 3/4/ hour and was a basic regulator with no other function.  Looking up the price afterwards, invoice did not list type or price, it appears that it would have cost me around $60 for the regulator and another $15 or so for the additional supplies necessary to install it and it was really a rather simple job with easy access.    Given that, it seems that $300 for less that  an hours worth of on site work,  company says it does not include commute time in its prices, is a little high.  While flat rate quotes are nice, they must take into consideration situations where the work load differs depending on the circumstances.  Therefore, unless you are at the upper end of the harder work needed than the average job. it can be argued that my estimated price of $300 for labor was more than a little high.  Maybe I am wrong since I have not used their services for years and  am not knowledgeable of the costs of equipment and professional labor today.  

New York Plumber's expert team will handle any home plumbing repair or plumbing fixture you may need: clogged drain, backflow, slab leaks, frozen pipes, solar water heater installation, basement flooding, leaking faucets, burst pipes, faulty garbage disposals, clogged sinks, leak detection, sump pump failure or any other plumbing repair service you may need - We do it all!
Ryan arrived right on time and was very cordial and friendly. He got right to work and provided me a very thorough description of the things that needed attention, and subsequently provided pricing for each of the requested service options and the extras that were also identified. He really did a great job and we were extremely satisfied. I recommended your company to a friend yesterday, and will definitely continue to use and recommend your company for future plumbing needs!Bravo Zulu Ryan.

Clogged screen: Many kitchen faucets have an aerator screen that improves water flow. These can become gradually clogged, resulting in reduced water pressure. These can usually be removed easily by unscrewing them from the end-point of the faucet. If you need to use a wrench or pliers, be sure to cover the metal with cloth to prevent scratching. Just rinse out the screen and screw it back on.
I was disappointed with the pressure of a tub and shower that were plumbed with 1/2 supply lines (2nd floor). Could be low pressure from the street, but I want to replace with 5/8. Plus, I'd like to have 2 back to back showers, one inside and one outside. So, I had intended to bring a 1 supply to both, then branch up to valves and shower head with 5/8. Finally, I thought pressure from the street was typically 55 to 70 psi and I am concerned if pvc can take that.Any thoughts?

Rooter Plumbing

×