Sometimes a faucet leak can be stopped by replacing the rubber washer at the end of a faucet stem or cartridge. This is a more common repair on older fixtures when things were built to last and designed to be able to be maintained. Other times the whole stem or cartridge needs replacement or the bibb seat deeper back into the fixture needs replacement. That leads to matching up the right components and often times making a trip to the hardware store or plumbing supply house necessary due to the many varieties, makes and models of faucets. My advice is to make sure your Plumber has faucet repair kit on their truck before having them come out to assess the issue.
One who fixes or repairs pipes. Plumber has a "b" in it because pipes were originally made of lead, (lead seemed a logical choice at the time, because of its resiliancy against rust... then people discovered what lead poisening was, and rust no longer seemed so bad!) and lead's abbreviation on the periodic table is pb (derived from its latin name).
Every plumbing problem is unique and very specific. Day or night, a weekday or a weekend, when you call Drain Rescue Plumbers in Toronto, we send a licensed plumber to your door within the hour! Once we arrive at your home, we thoroughly inspect the issue, assess the situation, identify what parts are needed and determine the number of labour hours required to resolve the problem. Read more. Read more
My plumbing experience was to have the plumbing disconnected under the sink so the counter top and new sink could be installed. I thought the service of $115 was high, but usually if there is an additional fees, it is usually rolled into the cost of repairs or labor. This company also charged 3.75 % for putting it on a credit card, which was not mentioned until I received the invoice in the mail after paying on the phone.
I was disappointed with the pressure of a tub and shower that were plumbed with 1/2 supply lines (2nd floor). Could be low pressure from the street, but I want to replace with 5/8. Plus, I'd like to have 2 back to back showers, one inside and one outside. So, I had intended to bring a 1 supply to both, then branch up to valves and shower head with 5/8. Finally, I thought pressure from the street was typically 55 to 70 psi and I am concerned if pvc can take that.Any thoughts?