Wedgeworth Plumbing, is a Texas (TX) Plumbing, Water Heater, Piping, Drain Cleaning, Sewer & Water Line service, replacement and maintenance Company located in Houston area. Wedgeworth Plumbing employs only the best technician and plumber for plumbing repair, water heater repair, and piping repair as well as plumbing replacement, sewer & water line replacement, and water heater replacement in Baytown TX, Bellaire TX, Cypress TX, Deer Park TX, Dickinson TX, Friendswood TX, Houston TX, Katy TX, Kemah TX, La Porte TX, League City TX, Missouri City TX, North Houston TX, Pasadena TX, Pearland TX, Richmond TX, Rosenberg TX, Santa Fe TX, Seabrook TX, South Houston TX, Spring TX, Stafford TX, Sugar Land TX, and Webster TX. So when you ask to find "A good plumbing repair or service company near me", you've come to the right place. To set-up a repair service estimate or replacement estimate, call (832) 867-5309. Wedgeworth Plumbing services all plumbing, piping, filter, and water heater brands including AO Smith, Bradford White, Rheem, Rinnai, State Water Heaters, among many others.
Using corrosive chemicals to dissolve a clog is like throwing a grenade down a gopher hole. Instead, Wroblewski recommends flushing your drains weekly with a half cup of baking soda and one cup of vinegar. Let it fizz in the drain for ten minutes, then pour in four cups of boiling water. Find out about the plumbing nightmares that will make you cringe.
Home repairs and maintenance shouldn’t get pushed to the bottom of the to-do list. Unfortunately, most people don’t think they need plumbing repair services until there’s an emergency. While some plumbing issues may seem minor, they could actually be serious emergencies in the making. Routine repairs from Mr. Rooter® Plumbing are affordable, and they’ll save you from paying for emergency plumbing rescue in the future.
I was disappointed with the pressure of a tub and shower that were plumbed with 1/2 supply lines (2nd floor). Could be low pressure from the street, but I want to replace with 5/8. Plus, I'd like to have 2 back to back showers, one inside and one outside. So, I had intended to bring a 1 supply to both, then branch up to valves and shower head with 5/8. Finally, I thought pressure from the street was typically 55 to 70 psi and I am concerned if pvc can take that.Any thoughts?