PLUMBING. Plumbing is the system that supplies, distributes, uses, and removes water from a building. Among the components used in the system are pipes, fittings, sinks, basins, faucets, valves, drains, toilets, and tubs. In colonial America, water used for cleaning or cooking was typically brought into a building by bucket and the wastewater was later removed in the same way. Elimination, for the most part, tended to take place out-side in a privy or outhouse. Although there were rare isolated examples of indoor toilets and running water based on or using English and European technology, it was not until the mid-nineteenth century that there were an appreciable number of plumbing installations. For many households they amounted to nothing more than a hand pump and kitchen sink. For a far smaller number it also might be hot and cold running water and what early on became known as the bathroom. During the 1840s and 1850s, the major elements of the bath were in place and consisted simply of a water closet or toilet and a "bathtub." Light washing still took place at the bedroom wash-stand with its basin, water pitcher, and slop jar or bucket. It was not until the 1860s that these items began to be replaced gradually by basins, faucets, and running water installed in the bathroom.
Help! The toilet won’t stop running. It’s a bummer, sure, but it’s something you don’t need to call your plumber about. In fact, DIYers should take note that it’s a quick fix that will cost you just $5. For instance, your handle might just be sticking, which can be solved by spraying some lubricant where the handle meets the porcelain. Ready to DIY? Here’s how to fix a running toilet.

Whatever your plumbing needs, BelRed has a solution. Our expert plumbers are on hand to assist with maintenance, service, and repair, or install water heaters, boilers, and other fixtures. Held to the same level of excellence as our heating and cooling systems are known for, our plumbing services and products can help prevent problems in the home before they occur.

According to standards set by the federal government, a low-flow showerhead uses no more than 2.5 gallons of water per minute at a water pressure of 80 pounds per square inch. That’s less than half the rate of water used by some older traditional showerhead models. Low-flow showerheads come in two main types, aerating, which creates a mist, or laminar-flow that sends water out in a steady stream.


PBT – flexible (usually gray or black) plastic pipe which is attached to barbed fittings and secured in place with a copper crimp ring. The primary manufacturer of PBT tubing and fittings was driven into bankruptcy by a class-action lawsuit over failures of this system.[citation needed] However, PB and PBT tubing has since returned to the market and codes, typically first for "exposed locations" such as risers.
This was Roberts fourth visit to her home, each time for different services and Zach‘s first. As always Tiffany in the office as well as the rest of the staff are more than communicative prior to the visit and keep you up-to-date on the travel time of the technician. The technicians are friendly, intelligent, accommodating, and beyond respectful and neat. I highly recommend Atomic Plumbing for any residential or commercial needs and would like to thank them for their personalized attention to our home.
Bob Carter started as with plumbers Indianapolis and moved his family to Greenwood in the late 1960’s.  He continued to do plumbing in Indianapolis and soon became a plumber in Greenwood as well.  Fast forward to today… Carter’s My Plumber is a 3rd Generation, family-owned Plumbing business operating from Greenwood, and serving the Indianapolis metro area. Son, Jamie and Grandson, Kelson now run the family business.

Rooter Plumbing Co

×