One who fixes or repairs pipes. Plumber has a "b" in it because pipes were originally made of lead, (lead seemed a logical choice at the time, because of its resiliancy against rust... then people discovered what lead poisening was, and rust no longer seemed so bad!) and lead's abbreviation on the periodic table is pb (derived from its latin name).
Had a main line back up on a cold rainy day. I checked google for a reliable plumber and called the first one that came up which was Atomic. Called and talked to DeAnne and she was very helpful. She had Ryan call me and I told him what was going on, he told me he would be here in 15 minutes. 12 minutes later Ryan pulled in and I showed him the problem, he told me the price and I told him to go for it. Ryan had this power snake the likes of which I have never seen before, it not only powered through the clog with no problem he was able to tell me how far down the pipe the clog was to within a couple of feet by the number of sections he used to reach it. To be on the safe side He ran the snake a few feet past the clog which put it just past the city clean out.Both DeAnne and Ryan were courteous and professional and got my problem resolved quickly and at a reasonable cost.I will be recommending Atomic to everyone I know. Hopefully Ryan will be able to take care of others with his wonder snake.
Once again it was Atomic Plumbing to the rescue. This company is absolutely the best plumbing company in the whole area. This time I had James M and Ryan S complete a very complicated, long re-piping/re-routing of my gas line to the hot water heater and furnace. The gas company had found a leak and had to “red tag”/cut off my gas until the leak was repaired. I called Atomic and as always I received the very best service. Tiffany answered the phone and was so personable, warm, and reassuring. She quickly scheduled the repair. James M and Ryan S arrived on time and got to work. James was lead tech and fully explained the job and then he and his apprentice got to work. Both James and Ryan worked diligently and hard all day to complete the work. To cut to the chase, the work was approved by the city inspector and the gas company turned my gas back on. I was so relieved that what I thought might be a nightmare was handled so professsionally and promptly. Oh yes, the gas company tech actually complimented the work done by James M and Ryan S. I am so grateful to both of them for their hard work, their obvious skill, and their friendly, professional manner. Way to go Atomic! You have my business for life!
A company may charge approximately $1,000 to replace a 50-gallon tank-style electric water heater (not including any upgrades required by building codes). Replacing a gas-powered water heater might cost $1,100 (not including code upgrades). Some companies roll the disposal of an old heater into the overall cost of the new water heater installation. Other professionals charge an additional removal fee that can range from $35 to $150.
If it’s a toilet issue you’ve got, you’re sure to find the right toilet parts and replacement pieces – including shutoff valves and supply lines – to get your toilet in tip-top shape. We’ve also got shower parts and shower valves, sink parts and faucet parts, as well as everything for bathtub repair – all to get your bathroom up and running in top-top shape.
If left unfixed, a running toilet or a leaky faucet can end up costing you hundreds of dollars. Check out your water bill and how your water is running. If you find your kitchen dripping non-stop and your water bill going higher, you may have a leak! Let Parker & Sons put a stop to those leaks. Our team of expert plumbers will make sure to get the work done faster, get it right the first time, and do it efficiently.
The straight sections of plumbing systems are called "pipes" or "tubes". A pipe is typically formed via casting or welding, whereas a tube is made through extrusion. Pipe normally has thicker walls and may be threaded or welded, while tubing is thinner-walled and requires special joining techniques such as brazing, compression fitting, crimping, or for plastics, solvent welding. These joining techniques are discussed in more detail in the piping and plumbing fittings article.

Several of the nation's larger cities were providing water to their residents during the first decade of the nineteenth century, but only infrequently was water actually brought into homes. City-provided water was used in large part to fight fires and flush streets. Household water was most likely taken from a tap located outside of the house or a common hydrant. For those not connected to city mains, and even some who were, there were still other ways to obtain water. If a stream was not near by, there was rain runoff from a roof. It could be collected in one or more tanks located in out-of-the-way places in a house and feed the plumbing system through gravity.
I have used atomic a couple of times and have received nothing but great service! When we first bought our house, we hadn't moved to the area yet and weren't moving for another month. We drove down for a weekend to get the A.C. replaced, and found the sink in the master bath (that the previous owner just had installed) had flooded the whole bedroom. I believe it was Eric who helped us, and he was wonderful. Despite it being July, and no A.C, he took care of us without complaint. And because we were going back home in the next couple days he made sure to get it done quickly!Recently we decided to replace our water heater and didn't hesitate to call Atomic. Ryan and Zach helped us this time and provided the same level of service I expected! They were polite, clean and made sure everything went smoothly. Atomic is definitely a little pricer than some smaller companies, but you get what you pay for and I'd rather pay to get it done correctly the first time than later when your water line snaps in the master bathroom and you're out of town.
Atomic Plumbing & Drain Cleaning provided Expert Plumber Jimmy Powell to diagnose and perform an emergency repair at my home. I had experienced flooding from poor workmanship by one of their competitors, who then refused to help me. When I contacted Atomic Plumbing with an emergency request, they stepped up immediately to assist me, and sent their plumber Jimmy P., who identified and corrected the poor workmanship that caused the flooding. Very knowledgeable in his trade, confident in the correction that he crafted, and he is a genuine good person. I would have been pleased with that much, but the reasonable price for the emergency work and the 1 year warranty that Jimmy presented on behalf of Atomic Plumbing brought it all home for me. This is a company that stands behind their good name and will send you the very best plumbing professionals when you are having a bad plumbing day. I am so glad that I contacted Atomic and met Jimmy. You will be too. Call Atomic Plumbing FIRST!
Nationally, the average water heater repair cost ranges between $120 and $200, although prices can range up to $400 or more. Water heater repair costs will depend on the type of water heater you have (tankless, electric, natural gas, etc.), the source of the problem, the cost for new parts, and labor rates in your area. Common water heater issues include problems with the thermocouple, thermostat, heating element and leaks. Most standard electric water heaters have two thermostats and two elements. One example for the cost to replace a bad thermostat is $185 for parts and labor. Replacing both the thermostat and the heating element could cost approximately $150-$200. The thermocouple is a safety device that senses when the pilot light is burning and signals the gas valve to close if the pilot light goes out. If your thermocouple is bad or corroded, the average cost to clean and repair it could be between $350 and $400. If your water heater has started to leak, it is usually more cost-effective to invest in a new water heater than to repair it, unless you’re covered by a warranty.

Call it plumber, flow pipes, flush, pipes, plumber reloaded, pipefitter and so on. Now the best pipe puzzle game has arrived on Windows Phone. Plumber is a free and simple to play puzzle game in which you must race against time to drain the water and prevent a flood from happening. Simply tap the different pipe pieces to rotate and connect them together to form a complete chain from left to right. To gain bonus points, connect more pipes in the chain and the water will drain faster too. There are four difficulty level available to suit your style: Easy, Medium, Hard and Insane. As the level progresses, the water level increases faster and faster. You need to be fast and creative with the use of special items such as Locked Pipes, Screwdrivers, Fixed Pipes, Gold Pipes and Stopcocks to help you advance into the next levels to become an undisputed plumber. Submit your scores into the online leaderboards and compete with players from all around the world! Download it now and get ready to fix leaks and prevent the flood!
The most common residential drain to cause problems is the kitchen sink drain. Food particles, grease, soap or detergent build up can all, over time, slow down or completely block the flow of water down to the septic or sewer system. A garbage disposal as well as an installed dishwasher add more pipes to the mix which create more potential for clogs.

Plumbing Service Co

×