I was disappointed with the pressure of a tub and shower that were plumbed with 1/2 supply lines (2nd floor). Could be low pressure from the street, but I want to replace with 5/8. Plus, I'd like to have 2 back to back showers, one inside and one outside. So, I had intended to bring a 1 supply to both, then branch up to valves and shower head with 5/8. Finally, I thought pressure from the street was typically 55 to 70 psi and I am concerned if pvc can take that.Any thoughts?
For many centuries, lead was the favoured material for water pipes, because its malleability made it practical to work into the desired shape. (Such use was so common that the word "plumbing" derives from plumbum, the Latin word for lead.) This was a source of lead-related health problems in the years before the health hazards of ingesting lead were fully understood; among these were stillbirths and high rates of infant mortality. Lead water pipes were still widely used in the early 20th century, and remain in many households. In addition, lead-tin alloy solder was commonly used to join copper pipes, but modern practice uses tin-antimony alloy solder instead, in order to eliminate lead hazards.
Present-day water-supply systems use a network of high-pressure pumps, and pipes in buildings are now made of copper, brass, plastic (particularly cross-linked polyethylene called PEX, which is estimated to be used in 60% of single-family homes), or other nontoxic material. Due to its toxicity, most cities moved away from lead water-supply piping by the 1920s in the United States, although lead pipes were approved by national plumbing codes into the 1980s, and lead was used in plumbing solder for drinking water until it was banned in 1986. Drain and vent lines are made of plastic, steel, cast-iron, or lead.
Working as one harmonious unit, the two pipe networks which make up your residential plumbing system have very specific functions: whereas water pipes supply fresh water to your home, the drain system (known as DWV) takes out contaminated water. To ensure the harmonious flow of your plumbing system, ask your local plumber to perform routine maintenance checks.
We have the ability to replace your sewer line without destroying your yard or driveway by digging the old, traditional way. When you re-line your sewer, it eliminates all cracks, leaks, holes or roots that may be causing trouble to your system. Option One Plumbings is your #1 plumber in Phoenix, San Diego and the Inland Empire for all of your sewer line fixes.
Where plumbing had been a mostly locally regulated matter for most of its history, the federal government became involved in the early 1990s. Until the 1950s, toilets generally used five or more gallons per flush (GPF). During the decades that followed, the plumbing industry reduced the standard volume for toilet flush tanks to 3.5 gallons. A further reduction in volume resulted from the Energy Policy Act of 1992, which in the name of conservation mandated that all new toilets made in the United States must use no more than 1.6 GPF. The same legislation also regulated the flow in shower heads and faucets. Although the first low-flow toilets proved un-satisfactory and were met with public disapproval, redesigned equipment employing new technology has removed most objections.
Those who attempted to bring plumbing indoors faced technical as well as attitudinal challenges. Decisions on how wastewater was removed required as much concern as those made to ensure an adequate water supply. But equally vexing was the prevailing miasma theory of disease, which held that illnesses stemmed from "bad air" that was readily identifiable by its offensive odor. This led to a distrust of early indoor plumbing that tended to leak and a deadly fear of the sewer gas that accompanied the leaks. It is no wonder then that many individuals maintained a strong belief that elimination was best taken care of out of doors.