CON'T FROM COMMENTS EARLIER.  However,  the  installation took less than 3/4/ hour and was a basic regulator with no other function.  Looking up the price afterwards, invoice did not list type or price, it appears that it would have cost me around $60 for the regulator and another $15 or so for the additional supplies necessary to install it and it was really a rather simple job with easy access.    Given that, it seems that $300 for less that  an hours worth of on site work,  company says it does not include commute time in its prices, is a little high.  While flat rate quotes are nice, they must take into consideration situations where the work load differs depending on the circumstances.  Therefore, unless you are at the upper end of the harder work needed than the average job. it can be argued that my estimated price of $300 for labor was more than a little high.  Maybe I am wrong since I have not used their services for years and  am not knowledgeable of the costs of equipment and professional labor today.  
JJ's Plumbing Repair has no control over, and assumes no responsibility for, the content, privacy policies, or practices of any third party web sites or services. You further acknowledge and agree that JJ's Plumbing Repair shall not be responsible or liable, directly or indirectly, for any damage or loss caused or alleged to be caused by or in connection with use of or reliance on any such content, goods or services available on or through any such web sites or services.

Clear the trap: If the above methods do not work, the next step would be to remove the P-trap under the sink. Place a bucket underneath the area to catch water then unscrew the two threaded caps that hold the curved section of the pipe in place. Nowadays, most kitchen drains are made of white PVC pipe with connections that can be unscrewed by hand.
Water is a necessary part of living in our homes so before the project begins, ask when the main water valve will be turned off and how that might affect the rest of the home. A good plumber will be aware that your family may need access to the room they're working in – request that your plumber stick to a schedule so that expectations are clear. Find out if your plumber needs access to the driveway or any other part of your home.
I was disappointed with the pressure of a tub and shower that were plumbed with 1/2 supply lines (2nd floor). Could be low pressure from the street, but I want to replace with 5/8. Plus, I'd like to have 2 back to back showers, one inside and one outside. So, I had intended to bring a 1 supply to both, then branch up to valves and shower head with 5/8. Finally, I thought pressure from the street was typically 55 to 70 psi and I am concerned if pvc can take that.Any thoughts?

Rooter Plumbing

×